ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM CONFIG > SNMP > SNMP COMMUNITIES > IP ADDRESS
Write security: 3; Read security: 5
Specifies the IP address of the network manager.
SYSTEM CONFIG > SNMP > SNMP COMMUNITIES > PRIVILEGES
Write security: 3; Read security: 5
Defines the GET (read-only) and GET/SET (read and write) privileges.
SYSTEM CONFIG > SNMP > SNMP COMMUNITIES > GET NAME
Write security: 3; Read security: 5
Defines the community name for GET access. This value must match the GET name defined on the network
management station (NMS). PUBLIC is the default name.
SYSTEM CONFIG > SNMP > SNMP COMMUNITIES > SET NAME
Write security: 3; Read security: 5
Defines the community name for SET access. This value must match either the GET or SET name defined
on the network management station (NMS). PUBLIC is the default name.
SYSTEM CONFIG > SNMP > TRAP TRANSMISSION
Write security: 3; Read security: 5
Enables and disables SNMP trap transmission.
SYSTEM CONFIG > SNMP > AUTHEN TRAP TRANSMISSION
Write security: 3; Read security: 5
Enables and disables the authentication failure trap. The authentication failure trap is sent (when ENABLED)
each time authenticated access to the ATLAS 550 fails.
SYSTEM CONFIG > SNMP > TRAPS DESTINATION
Write security: 3; Read security: 5
Defines the destination for SNMP traps as follows:
SYSTEM CONFIG > SNMP > TRAPS DESTINATION > IP ADDRESS
Write security: 3; Read security: 5
Identifies the IP address for the network management station (NMS) to send traps to.
SYSTEM CONFIG > SNMP > TRAPS DESTINATION > COMMUNITY
Write security: 3; Read security: 5
Defines the community name for trap destinations. This name must match the community name defined on
the network management station (NMS).
84 © 2004 ADTRAN, Inc. 61200305L2-1B