ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SPID NUMBER
Write security: 3; Read security: 5
Defines the SPID number(s) used for this BRI line. Although the value of the SPID is not significant,
a SPID must be entered for each phone number. For convenience, the SPID can be set to be the same
as the phone number. The Quad BRI S/T Module does not support autoSPID detection software
which some terminal adapters offer.
CALLS
No SPID Number is needed for the Euro-ISDN Switch Type.
Write security: 3; Read security: 5
For User terminations, the number of calls is fixed at 2.
D64, D56, AUDIO, SPEECH
Write security: 3; Read security: 5
These options reflect the network provisions for this SPID. If the BRI was purchased with different
services provisioned for the SPIDs, then the call must match the services supported.
DIAL PLAN (PKT ENDPT - PACKET ENDPOINTS)
DIAL PLAN (PKT ENDPT) > USER TERM
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports configured as packet endpoints.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > OUTDIAL NUMBER
Write security: 3; Read security: 5
Defines the number dialed to originate a call.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > OUTGOING CALL TYPE
Write security: 3; Read security: 5
Selects the terminating resource type, either DIGITAL 64K or DIGITAL 56K.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > REDIAL TIMER
Write security: 3; Read security: 5
Selects the time delay in seconds between redial attempts.
61200305L2-1B © 2004 ADTRAN, Inc. 297