ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
PACKET MANAGER > PACKET ENDPNTS > STATUS
Read security: 5
Displays the status of each packet endpoint including the packet endpoint name, the protocol type, the
signaling role, the signaling type, the signaling activity, and the connections. The configuration choices are
given below.
PACKET MANAGER > PACKET ENDPNTS > STATUS > ENDPNT NAME
Read security: 5
Displays the packet endpoint name as defined in the PACKET ENDPNTS/CONFIG menu.
PACKET MANAGER > PACKET ENDPNTS > STATUS > PROTOCOL
Read security: 5
Displays the layer 2 protocol for this packet endpoint. FR indicates this packet endpoint is configured for
frame relay. TBOP indicates this packet endpoint is configured for Transparent Bit Oriented Protocol
(TBOP). PPP indicates this packet endpoint is configured for the Point-to-Point Protocol. SDLC indicates
this packet endpoint is configured for SDLC signaling.
SDLC signaling is only available using the Legacy Data Option Module (P/N 1200342L1).
PACKET MANAGER > PACKET ENDPNTS > STATUS > SIG ROLE
Read security: 5
Displays the frame relay signaling role for this packet endpoint. The following options indicate the
signaling role for this packet endpoint. These settings are not applicable for PPP.
USER Indicates the user side of the User to Network Interface (UNI).
NETWORK Indicates the network side of the UNI.
BOTH Indicates the packet endpoint is operating in Network to Network Interface
(NNI) mode.
PACKET MANAGER > PACKET ENDPNTS > STATUS > SIG TYPE
Read security: 5
Displays the frame relay signaling type used on this packet endpoint. This setting is not applicable for PPP,
TBOP, or SDLC endpoints.
ANNEX A Signaling using ITU-T Q.933-A.
ANNEX D Signaling using ANSI T1.617-D.
LMI Signaling using Group of Four.
188 © 2004 ADTRAN, Inc. 61200305L2-1B