ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
PACKET MANAGER > PACKET ENDPNTS > STATUS > SIG STATE - FRAME RELAY
Read security: 5
(Valid only for Frame Relay endpoints.) Indicates the frame relay signaling state on this packet endpoint.
The possible states are defined below.
UP Indicates that there is active frame relay signaling on this endpoint. The
packet endpoint must be defined by the frame relay configuration
settings to show active frame relay signaling.
DOWN The packet endpoint stays in this state only when the physical line is
down.
PACKET MANAGER > PACKET ENDPNTS > STATUS > SIG STATE - PPP
Read security: 5
(Valid only for PPP endpoints.) Indicates the status of the PPP negotiation.The possible states are defined
below.
INITIAL This is the first state of LCP negotiation. If the packet endpoint is connected
to a physical port in the DEDICATED MAP, this state will usually transition to
the STARTING state to begin the PPP negotiation.
STARTING The packet endpoint stays in this state only when the physical line is down.
REQ - SENT The packet endpoint has sent an LCP configuration request to the peer and
is waiting for an “acknowledge.”
ACK - RECVD The packet endpoint has received an “acknowledge” from the peer for the
sent configuration request.
ACK - SENT The packet endpoint has acknowledged the peer’s configuration request,
but the peer has not acknowledged us.
OPENED LCP negotiation on the packet endpoint has finished; authentication, if
enabled, occurs now.
CLOSING The packet endpoint has sent the peer a “terminate” request and is waiting
for the peer’s acknowledgement.
CLOSED The packet endpoint has received the peer’s acknowledgement to the sent
terminate request; this is followed by the initial state.
STOPPING The packet endpoint has received a terminate request from the peer.
STOPPED The packet endpoint has acknowledged the peer’s terminate request.
NOT CONNECTED The packet endpoint is not connected to the router in the PACKET CNCTS
menu.
PACKET MANAGER > PACKET ENDPNTS > STATUS > CURRENT PORT
Read security: 5
Displays the connections for the packet endpoint. The letter U in this field indicates that this packet
endpoint is used in the PACKET CNCTS map. The remainder of the field indicates the physical port this
packet endpoint is connected to in the DEDICATED MAP. If the port is a channelized interface such as a T1,
the DS0 assignment is also provided.
61200305L2-1B © 2004 ADTRAN, Inc. 189