ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > SUPPORT DBU HANDSHAKE
Write security: 3; Read security: 5
DBU HANDSHAKE must be disabled for DBU between two ATLAS products.
This option is only available when the packet endpoint selected in the PORT/PEP field has backup sublinks.
SUPPORT DBU HANDSHAKE enables/disables the generation and acceptance of ADTRAN frame relay
handshake upon connection. If the endpoint is configured to route incoming calls based on the handshake
information, this option is automatically enabled. If another call routing method is in effect, however, this
option can be enabled to support the use of handshake information at the far end of the link.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > SUPPORT DBU HANDSHAKE
Write security: 3; Read security: 5
Controls contents of the ADTRAN frame relay handshake upon connection of a backup PVC. Normally
this field should be set to AUTO. The FORCED mode is present for compatibility with older IQ units.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > CALL PARTY NUMBER
Write security: 3; Read security: 5
(Visible only if GROUP is selected in the PORT/PEP field.) Enter the expected calling part number in this
field. The ATLAS 550 will use the number entered here to compare to the number presented by the
incoming call when configured to route based on Call Party Number.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > MIN DS0’S
Write security: 3; Read security: 5
Set this to 1 for typical single-call connections. A value greater than 1 will restrict connections to endpoints
supporting aggregation (e.g., BONDING) of the specified number of DS0s.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > MAX DS0’S
Write security: 3; Read security: 5
Set this to 1 for typical single-call connections. A value greater than 1 will accommodate connections to
endpoints supporting aggregation (e.g., BONDING) of up to the specified number of DS0s. This also sets
the number of DS0s presented in the negotiation of outgoing aggregate calls.
DIAL PLAN (PKT ENDPT) > USER TERM > IFCE CONFIG > CALL ROUTING TABLE
Write security: 3; Read security: 5
This table is only visible if GROUP is selected in the PRT/PEP field. The table format changes, based on the
selected routing option. For each case, CALL PARAMS contain OUTDIAL#, CALLER ID, SOURCE ID, and
MIN/MAX DS0S, as described above.
61200305L2-1B © 2004 ADTRAN, Inc. 299