ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
MODULES (ADPCM-32) > STATUS > STATUS
Read security: 5
Indicates the condition of the individual packet voice device. This field may display the following:
N/A This device is not populated on the selected 32 Channel ADPCM Resource
Module.
AVAILABLE This resource is available for voice compression and functioning properly.
PENDING This resource is currently changing state.
BUSY This resource is currently in use.
TESTING This resource is currently being tested and is not available for use.
FAILED This resource has failed testing and is not available for use.
RELOADED This resource was reinitialized after excessive errors.
MODULES (ADPCM-32) > STATUS > ALGORITHM
Read security: 5
Denotes the voice compression algorithm being used by the packet voice device. Voice data may be
encoded using any of a variety of compression algorithms or codecs. The codec for an individual call is
selected when the connection is configured. When ATLAS 550 assigns a packet voice device to a
particular call, the that packet voice devise is switched to the proper codec. Refer to the Frame Relay menu
section of this manual for more information.
Some voice compression standards may be used only under specific licensing
arrangements due to existing patents. The ATLAS 550 provides complete management of
these licensed resources; therefore, users are not required to take additional steps to
ensure conformance with licensing provisions. For example, the ATLAS 550 manages its
resources so users never exceed the maximum licensed number of simultaneous
connections.
MODULES (ADPCM-32) > STATUS > CONNECTION
Read security: 5
Helps identify a suspect packet voice device if a particular call reports poor quality. The displayed packet
identifier and the dial plan endpoint identify the call using this packet voice device.
MODULES (ADPCM-32) > CONFIG
Write security: 4; Read security: 5
Provides diagnostic tools for suspected problems; under normal operation, users do not configure the
packet voice devices.
MODULES (ADPCM-32) > CONFIG > CONFIGURE ADPCM-32 DEVICES
Write security: 4; Read security: 5
Contains configuration parameters for individual ADPCM-32 devices.
61200305L2-1B © 2004 ADTRAN, Inc. 181