ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SYSTEM CONFIG > SNMP > TRAPS DESTINATION > TRAP FILTERING
Write security: 3; Read security: 5
Sets the minimum severity level required for a system event to generate an SNMP trap. If a trap event
occurs with a severity level equal to or more severe than the trap type’s current threshold setting, the event
is sent as an SNMP trap. (For a listing of all MIBs containing traps and their severity levels, check the
ADTRAN Support website at www.adtran.com. Click Service/Support > Technical Support > ATLAS
Products > ATLAS 550 > MIBs.) The available selections for the threshold levels are: DISABLED, CRITICAL,
MAJOR, MINOR, WARNING, NORMAL, and INFO.
SYSTEM CONFIG > SNMP > TRAPS DESTINATION > STATION TYPE
Write security: 3; Read security: 5
To deliver the SNMP trap packet with the COMMUNITY NAME unchanged, define the STATION TYPE as
NORMAL. If you are using T-Watch PRO, define the STATION TYPE as T-WATCH MGMT and append the
COMMUNITY NAME with “.ADLP ADDRESS.” Within the SNMP trap packet, this field is automatically
updated before it is sent to the management station.
SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS
Write security: 3; Read security: 5
Defines performance threshold values for DS1 Line and Path statistics recorded in a 15-minute interval.
Refer to the ADTRAN Enterprise MIB and the DS1 Extension MIB (These MIB listings are available on
the documentation CD or the ADTRAN website at www.adtran.com for more MIB-specific information.
Click Service/Support >Technical Support > ATLAS Products > ATLAS 550 > MIBs.) If a statistic value
exceeds its threshold value, then the corresponding Alert Trap will be sent if the Alert Event is armed and
Alert Traps are enabled. These thresholds apply to all DS1 interfaces in the system.
SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT ES THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Current 15 minute Errored Seconds (ES)
parameter. The default value is 65 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT SES THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Seconds (SES)
parameter. The default value is 10 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT SEFS THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Current 15 minute Severely Errored Framing
Seconds (SEFS) parameter. The default value is 2 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 CURRENT PERF THRESHOLDS > CURRENT UAS THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Current 15 minute Unavailable Seconds (UAS)
parameter. The default value is 10 for an approximate BER level of 10E-5.
61200305L2-1B © 2004 ADTRAN, Inc. 85