ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM CONFIG > SNMP > ASP ENDPOINT COMMUNITIES > ADLP ADDRESS
Write security: 0; Read security: 0
Enter the ADLP address (Unit ID) of the remote unit. Only traps containing an ADLP address listed here
will be accepted.
SYSTEM CONFIG > SNMP > ASP ENDPOINT COMMUNITIES > ADLP PASSWORD
Write security: 0; Read security: 0
Enter the ADLP password (Unit Password) of the remote unit. The password will be verified before traps
will be accepted from the remote unit.
SYSTEM CONFIG > SNMP > SNMP/ASP PROXY
Write security: 0; Read security: 0
Enables or disables Get_Request capabilities for remote units. When enabled, this feature allows SNMP
requests to be sent from the network management station (NMS) through the ATLAS 550 to the selected
remote unit. Remote units must be ADTRAN TSU 100 Series or ISU 512 products. All remote units must
be listed in the ASP ENDPOINT COMMUNITIES list.
SYSTEM CONFIG > SNMP > SNMP/ASP POLLING
Write security: 0; Read security: 0
Enables or disables trap polling through the ATLAS 550 to remote ADTRAN TSU 100 Series or ISU 512
units. When enabled, this feature allows the ATLAS 550 to forward any traps received from remote units
to the network management station (NMS) listed in the TRAPS DESTINATION field. The remote unit must be
listed in the ASP ENDPOINT COMMUNITIES for the traps to be forwarded.
SYSTEM CONFIG > EVENT LOGGING
Write security: 3; Read security: 5
Sets the system event severity level threshold for each of the ATLAS 550 system event types. When a
system event occurs, the event is logged if the event’s severity level is equal to or more severe than the
event type’s current threshold setting. See Section 7, System Event Logging, for detailed information on the
system events.
SYSTEM CONFIG > SYSLOG SETUP
Write security: 3; Read security: 3
Configures the ATLAS 550 Syslog client for use with a Syslog server (supplied with ADTRAN Utilities or
available on most UNIX platforms).
SYSTEM CONFIG > SYSLOG SETUP > TRANSMISSION
Write security: 3; Read security: 3
Enables or disables the transmission of log events to the external Syslog server.
SYSTEM CONFIG > SYSLOG SETUP > HOST IP ADDRESS
Write security: 3; Read security: 3
Lists the IP address of the external server that is running the Syslog host daemon.
88 © 2004 ADTRAN, Inc. 61200305L2-1B