ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
MODULES (V35NX-2) > ALARM STATUS
Read security: 5
Displays the current alarm status.
MODULES (V35NX-2) > ALARM STATUS > PRT
Read security: 5
Indicates the port number.
MODULES (V35NX-2) > ALARM STATUS > ALARMS
Read security: 5
Displays an alarm condition on the ATLAS 550 unit.
SLIP A rate mismatch exists between the DTE clock and the network-side clock (as
set by DS0 assignment).
PLL The Nx port is not able to lock onto the clock provided by the network interface.
ZERO The DTE is sending an excessive number of consecutive zeroes to the network
interface.
NO EXT CLK The DTE is not providing an external transmit clock. This alarm displays only if
the Nx port is configured to get its transmit clock from the DTE.
PKT EP ALM A packet endpoint has detected missing or incorrect framing.
MODULES (V35NX-2) > DTE STATUS
Read security: 5
Shows the status of key DTE interface signals. An asterisk (*) indicates the presence of a signal and a
hyphen (-) indicates no signal present.
MODULES (V35NX-2) > DTE STATUS > PRT
Read security: 5
Operating port number. There are 2 available interfaces on the Dual Nx56/64 Option Module.
MODULES (V35NX-2) > DTE STATUS > DTE STATUS
Read security: 5
The following signals are monitored (these options are read-only).
RTS Request to send from DTE RI Ring indicate to DTE
CTS Clear to send to DTE TD Transmit data from the DTE
DTR Data terminal ready from DTE RD Receive data toward the DTE
DSR Data set ready to DTE EC External clock present
DCD Data carrier detect to DTE
61200305L2-1B © 2004 ADTRAN, Inc. 129