ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DIAL PLAN (T1/PRI) > USER TERM (PRI) > IFCE CONFIG (PRI) > B CHANNEL SELECTION
Write security: 3; Read security: 5
Determines how the ATLAS 550 switchboard uses B channels for call routing. The Circular method can be
used for call load balancing among the available B channels on this interface.
NORMAL Always start with the last channel configured (i.e., for a full PRI channel 23 would
be used if available).
CIRCULAR Contiguous channels from last to first.
DIAL PLAN (T1/PRI) > USER TERM (PRI) > IFCE CONFIG (PRI) > BUSY OPTION
Write security: 3; Read security: 5
Defines the response propagated to the CPE upon receipt of a DISCONNECT USER-BUSY message from the
network.
NORMAL Send a Progress message to the CPE and map busy tones.
PASS-THRU Send a DISCONNECT USER-BUSY message to the User Term CPE device.
DIAL PLAN (T1/PRI) > USER TERM (RBS)
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which emulate an RBS T1 connection from
the network.
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS)
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > FIRST DS0
Write security: 3; Read security: 5
Defines the first DS0 for this endpoint.The ATLAS 550 uses DS0s, starting with this selection, to send and
receive calls to and from the network. The outgoing calls which are allowed or restricted over these DS0s
are set by OUT#ACCEPT (see page 181) and OUT#REJECT (see page 183).
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > NUMBER OF DS0S
Write security: 3; Read security: 5
Specifies the number of DS0s ATLAS 550 uses for this endpoint.
270 © 2004 ADTRAN, Inc. 61200305L2-1B