ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > SOURCE ID
Write security: 3; Read security: 5
Simplifies the creation of a DIAL PLAN in applications where the criterion for switching calls to a certain
endpoint is a function of which endpoint originated the call.
DEFAULT VALUE = 0. Zero is the default ID for all endpoints and all accept numbers. With default
values, all calls are routed based only on the dialed number.
Multiple endpoints can have the same SOURCE ID.
When creating the CALL ACCEPT list, specify a SOURCE ID(s) as well as a dialed number or range of
dialed numbers to accept.
Example: An application requires that all calls that originate from Port 1 of the ATLAS 830 in Slot 1 be
switched to Port 2 of that same module. Assign a unique SOURCE ID (e.g., 7) to Port 1 of the module, and
then configure Port 2 to only accept calls from that unique SOURCE ID (7).
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > DIAL ON OFFHOOK
Write security: 3; Read security: 5
Defines a number that is automatically sent to the switchboard when a call on this endpoint is initiated
(goes off hook).
The DIAL ON OFFHOOK number must be specific (i.e., no wildcards).
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > DS0 SELECTION
Write security: 3; Read security: 5
Determines how the ATLAS 550 switchboard uses DS0s for call routing.
NORMAL Always start with the last channel configured (i.e., for a full PRI channel 23
would be used if available).
CIRCULAR Contiguous channels from last to first. Use for call load balancing among the
available DS0s on this interface.
ALIGNED Provides the ability to maintain alignment between T1s as if they were in
dedicated map mode. This scenario requires DS0 SELECTION set to ALIGNED on
both interfaces (usually on User Term and on Net Term). An interface that has
DS0 SELECTION set to ALIGNED will only process a call from the switchboard on
the same DS0 that the incoming call was received.
Example: The unit receives an incoming call on DS0 17. The switchboard looks for an interface who has
matching accept criteria to the number it received. A match is found on interface “Z” that has DS0
SELECTION set to ALIGNED. This causes interface “Z” to only process the call if it has DS0 17 available. If
all matching interfaces have DS0 SELECTION set to ALIGNED and none of those interfaces have DS0 17
available, then a busy or fast busy will be returned to the calling party.
61200305L2-1B © 2004 ADTRAN, Inc. 273