ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
TD CLOCK SOURCE
Write security: 3; Read security: 5
Configures the interface to provide or recover data clocking.
This clock source is used ONLY on the Legacy Data Option Module and cannot be used as
a source for system timing.
TRANSMIT IDLE CODE
Write security: 3; Read security: 5
Configures the port to use Flags or Ones as the idle code.
DEDICATED MAPS (PKT ENDPT - PACKET ENDPOINT)
DEDICATED MAPS (PKT ENDPT) > CREATE/EDIT MAPS > CONNECTS
Write security: 3; Read security: 5
To assign a packet endpoint to a physical port, select the port in the FROM SLOT/PORT field and configure
the TO SLOT/PORT as follows:
DEDICATED MAPS (PKT ENDPT) > CREATE/EDIT MAPS > CONNECTS > TO SLOT/SERVICE
Write security: 3; Read security: 5
Select PKT ENDPNT to activate a list of available packet endpoints in the TO PORT field.
DEDICATED MAPS (PKT ENDPT) > CREATE/EDIT MAPS > CONNECTS > TO PORT/PEP
Write security: 3; Read security: 5
Press and select the appropriate packet endpoint to assign the endpoint to a physical port.
DEDICATED MAPS (PKT ENDPT) > CREATE/EDIT MAPS > CONNECTS > TO/FROM CONFIG
Write security: 3; Read security: 5
Specifies the configuration for the TO/FROM connection. The following selections apply to the packet
endpoint:
TRANSMIT IDLE CODE
Write security: 3; Read security: 5
Configures the ATLAS 550 to send idle code on the packet endpoint with marks or flags.
244 © 2004 ADTRAN, Inc. 61200305L2-1B