ATLAS 550 System Manual - Adtran

Section 5 DLP-6 ATLAS 550 System Manual
Perform the following steps in the order listed.
1. Connect to the ATLAS 550 using the ETHERNET interface.
If you are not already connected to the unit’s ETHERNET port using Telnet client software, use the
procedure in DLP-3, Setting IP Parameters for the ATLAS 550, to connect to the unit.
2. Log in to the unit using the read-write password (see DLP-2, Logging in to the ATLAS 550, for details).
3. Go to the SYSTEM UTILITY menu and select UPDATE FIRMWARE; press .
4. Select MODULE SLOT and press .
Select the appropriate module slot to update. The module slot for the ATLAS 550 system controller is
module slot 0.
5. Go to the TRANSFER METHOD menu and select TFTP.
6. Enter into TFTP SERVER IP ADDRESS, the IP address of the network TFTP server.
7. Enter into TFTP SERVER FILENAME, the full path name and filename of the update file.
8. From the RESTART SCHEDULE menu, select the time for the module to perform a restart after
completing the update.
RESTART IMMEDIATELY AFTER UPDATE restarts the system immediately after the update is complete.
RESTART AT SPECIFIED DATE AND TIME allows you to select when the updated system will restart. If you
select this option, a new field called RESTART DATE AND TIME displays below the current field. To use
that option, enter the time in 24-hour format (such as 23:00:00 for 11:00 pm). Enter the date in
mm-dd-yyyy format (for example, 06-30-2004).
9. Select VIEW CURRENT UPDATE STATUS to verify the progress of the current firmware update or to
identify any errors encountered during the download.
Refer to the table on the following page for a detailed description of messages found in this field.
10. Select BEGIN FIRMWARE UPDATE to start the update. Enter Y to confirm the transfer and to set up the
module to receive the TFTP upload.
During the TFTP upload, the following status messages display in CURRENT UPDATE STATUS to
indicate the progress of the upload:
CONTACTING SERVER Indicates communication with the TFTP network server is trying to be
established with the specified server address in the TFTP SERVER IP
ADDRESS field.
BEGINNING TFTP Indicates communication with the TFTP network server has been
TRANSFER
established and the update file is being transferred between the ATLAS
550 and the TFTP network server.
COMPLETED Indicates the ATLAS 550 successfully received the update file.
ERROR: FILE NOT FOUND Indicates the TFTP network server was unable to locate the specified file
name or path in the TFTP SERVER FILENAME field.
ERROR: ACCESS Indicates the TFTP network server denied the ATLAS 550 access to the
VIOLATION
given update filename and path. Please verify appropriate user rights are
selected for the specified path.
324 © 2004 ADTRAN, Inc. 61200305L2-1B