ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM CONFIG
The SYSTEM CONFIG menu allows you to set up the ATLAS 550 operational configuration. Figure 5 shows
the items included in this menu.
Figure 5. System Config Menu
SYSTEM CONFIG > PRIMARY TIMING SOURCE
Write security: 1; Read security: 5
Selects the primary timing source. You can select either INTERNAL or any port available on the system that
is capable of providing timing. Please refer to the specific module information to determine if a port can
provide timing for the system.
SYSTEM CONFIG > BACKUP TIMING SOURCE
Write security: 1; Read security: 5
Selects the secondary timing source. You can select either INTERNAL or any port available on the system
that is capable of providing timing. Please refer to the specific module information to determine if a port
can provide timing for the system. The ATLAS 550 uses the backup timing source if the primary timing
source goes into alarm. The BACKUP TIMING SOURCE should be different from the PRIMARY TIMING SOURCE
for the most reliable operation.
SYSTEM CONFIG > ADLP ADDRESS
Write security: 2; Read security: 5
Shows the system ADTRAN Data Link Layer Protocol (ADLP) address for connecting remote devices to
ADTRAN management software. The allowable range is between 2 and 65520. Enter a value not used by
any other ADTRAN units controlled by the management software.
80 © 2004 ADTRAN, Inc. 61200305L2-1B