ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > DIRECT INWARD DIALING
Write security: 3; Read security: 5
Defines whether Direct Inward Dialing (DID) is being used by the network. If DID is ENABLED, then the
following information must be defined.
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > CALLER ID NUMBER
Write security: 3; Read security: 5
Defines the number the ATLAS 550 uses to provide caller ID to the network for outgoing calls sent
through this endpoint. This item is optional.
The Caller ID number must be specific (i.e., no wildcards).
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > DID DIGITS TRANSFERRED
Write security: 3; Read security: 5
Defines the number of digits sent to ATLAS 550 from the network if DID is used. This option only displays
if DID is set to ENABLED.
If FEATURE GROUP D is used, DID only refers to DNIS digits.
DIAL PLAN (T1/PRI) > USER TERM (RBS) > IFCE CONFIG (RBS) > STRIP MSD
Write security: 3; Read security: 5
Strips a selected quantity (choose from NONE, 1, 2, and 3) of the most significant digits (MSD) of a dialed
number prior to being forwarded out of the port.
Example: A network port could be set to accept all calls beginning with 9 (9$), and then with STRIP MSD
set to 1, all digits would be sent toward the network except the leading 9.
STRIP MSD does not affect CALL ACCEPT criteria. All of the digits (including the MSDs that
are subsequently stripped) are used as accept criterion.
272 © 2004 ADTRAN, Inc. 61200305L2-1B