ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM UTILITY > CONFIG TRANSFER > SAVE CONFIG REMOTELY
Write security: 3; Read security: 5
Saves the configuration file specified in TFTP SERVER FILENAME to the server identified in TFTP SERVER
IP ADDRESS. To start this command, enter Y. To cancel this command, enter N.
SYSTEM UTILITY > SYSTEM UTILIZATION
Write security: 0; Read security: 0
Displays statistics related to the ATLAS 550 internal operating system. Please check with ADTRAN
Technical Support before attempting to use this menu.
SYSTEM UTILITY > SYSTEM SELFTEST
Write security: 3; Read security: 5
Initiates a system self-test. The self-test consists of memory tests and data integrity tests for each installed
module.
Self-tests disrupt data flow.
SYSTEM UTILITY > SYSTEM SELFTEST > SELFTEST
Write security: 3; Read security: 5
Activates the self-test. To confirm self-test activation, press Y; to cancel the self-test press N.
SYSTEM UTILITY > SYSTEM SELFTEST > SELECTED TESTS
Write security: 3; Read security: 5
Allows the user to select a system-wide test or an individual card test. Choose from ALL TESTS, SLOT: 0
SYS CTRL, or any other installed option/network/resource module.
SYSTEM UTILITY > SYSTEM SELFTEST > CURRENT TEST STATUS
Write security: 3; Read security: 5
Displays which part of self-test is currently active. See System Utility > System Selftest > View Selftest Log
for details on individual tests.
SYSTEM UTILITY > SYSTEM SELFTEST > CURRENT SLOT/PORT
Write security: 3; Read security: 5
Displays which slot and port is currently being tested.
SYSTEM UTILITY > SYSTEM SELFTEST > VIEW SELFTEST LOG
Read security: 5
Displays time-stamped log of the tests conducted and the Pass/Fail results. Self-tests verify data integrity
and processor control to each port. Each port is looped back and a data pattern is sent and tested.
96 © 2004 ADTRAN, Inc. 61200305L2-1B