ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
SYSTEM CONFIG > ETHERNET PORT > MAC ADDRESS
Read security: 5
Displays the system Ethernet Media Access Control (MAC) address. This field is read-only.
SYSTEM CONFIG > ETHERNET PORT > ETHERNET SPEED
Write security: 2; Read security: 5
Defines the rate at which the ETHERNET port operates. Choose from 10 MBPS or AUTO 10/100. When the
unit is set for AUTO 10/100, the ATLAS 550 auto-detects the data rate of the LAN and sets itself to that
rate, either 10 or 100 Mbps.
SYSTEM CONFIG > ETHERNET PORT > DHCP STATUS
Read security: 5
Displays the current status of the DHCP client in the ATLAS 550. The following states are possible (per
RFC 2131): INIT, SELECTING, REQUESTING, BOUND, RENEWING, REBINDING, INIT-REBOOT, REBOOTING, and
NON-INIT.
SYSTEM CONFIG > ETHERNET PORT > LEASE EXPIRES
Read security: 5
Displays the date and time the current IP address lease will expire and a new one will be necessary.
SYSTEM CONFIG > ETHERNET PORT > RELEASE
Write security: 2; Read security: 5
Forces the ATLAS 550 to release the currently assigned IP address.
Once the IP address is manually released, the ATLAS 550 will not be available for Telnet
access until a manual renew is performed.
SYSTEM CONFIG > ETHERNET PORT > RENEW
Write security: 2; Read security: 5
Forces the ATLAS 550 to send a message to the DHCP server requesting a new IP address lease.
SYSTEM CONFIG > CHAIN PORT
Write security: 2; Read security: 5
Accepts input for configuring the ADMIN or CRAFT port located on the rear of the unit.
SYSTEM CONFIG > CHAIN PORT > PORT NAME
Write security: 2; Read security: 5
Defines the name of the ADMIN or CRAFT port. You can leave this field blank.
82 © 2004 ADTRAN, Inc. 61200305L2-1B