ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DIAL PLAN > GLOBAL PARAM > COLLISION RESPONSE
Write security: 0; Read security: 0
When forced, the COLLISION RESPONSE will enable the ATLAS to perform AUTOMATIC retransmission
of SETUP messages when faced with a collision situation. Forcing this response is not advised.
Use extreme caution when forcing COLLISION RESPONSE.
DIAL PLAN > GLOBAL PARAM > GLOBAL TONE TYPE
Write security: 1; Read security: 5
Specifies the dialing digit tone encoding to be used throughout the entire system. DTMF (dual-tone-multi
frequency) is the only available option.
DIAL PLAN (T1 NETWORK AND DUAL/QUAD T1/PRI MODULES)
All menu items in this section (listed as T1/PRI) apply to T1 Network and Dual/Quad Module interfaces
configured in the DIAL PLAN.
DIAL PLAN (T1/PRI) > NETWORK TERM (PRI)
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which terminate a PRI connection from the
network.
DIAL PLAN (T1/PRI) > NETWORK TERM (PRI) > IFCE CONFIG (PRI)
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
DIAL PLAN (T1/PRI) > NETWORK TERM (PRI) > IFCE CONFIG (PRI) > SWITCH TYPE
Write security: 3; Read security: 5
Defines the type of PRI switch to which the port is connected. If connected to another ATLAS 550, both
need to be set to the same switch type. The following options are available:
• Lucent 5E • National ISDN
• Northern DMS 100 • AT&T 4ESS
260 © 2004 ADTRAN, Inc. 61200305L2-1B