ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
PACKET MANAGER > PACKET ENDPNTS > CONFIG > PROT
Write security: 3; Read security: 5
Defines the protocol operating on this port. FRAME RELAY configures this packet endpoint for frame relay
signaling. TBOP configures this endpoint as transparent bit oriented protocol. PPP configures this packet
endpoint as point-to-point protocol. SDLC configures this packet endpoint as an SDLC endpoint.
SDLC is only available for use with the Legacy Data Option Module (P/N 1200342L1).
PACKET MANAGER > PACKET ENDPNTS > CONFIG > CONFIG - FRAME RELAY
Write security: 3; Read security: 5
Contains the configuration parameters for this packet endpoint.
SIGNALING ROLE
Write security: 3; Read security: 5
Displays the frame relay signaling role for this packet endpoint. The following options indicate the
signaling role of this packet endpoint.
OFF The remote device does not support frame relay signaling.
AUTO Detects the role of the device on the other end of the circuit and automatically sets
this packet endpoint to the appropriate value.
BOTH Operates in NNI mode.
NETWORK Acts as the network side of the UNI interface.
USER Acts as the user side of the UNI interface.
SIGNALING TYPE
Write security: 3; Read security: 5
Displays the frame relay signaling type for this packet endpoint. The following options indicate the
signaling type for this packet endpoint.
AUTO Detects the signaling type of the device on the other end of the circuit and
automatically sets this packet endpoint to the same signaling type.
ANNEX A Transmits and responds to ITU-T Q.933-A standards.
ANNEX D Transmits and responds to ANSI T1.617-D standards.
LMI Transmits and responds to Group of Four specifications.
USER POLL TIMER (T391)
Write security: 3; Read security: 5
Sets the polling interval to the network in seconds.
194 © 2004 ADTRAN, Inc. 61200305L2-1B