15.01.2013 Views

ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual - Adtran

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Section 5 DLP-4 <strong>ATLAS</strong> <strong>550</strong> <strong>System</strong> <strong>Manual</strong><br />

Perform the following steps in the order listed.<br />

1. Verify the <strong>ATLAS</strong> <strong>550</strong> IP address.<br />

If you do not already have the IP Address for the <strong>ATLAS</strong> <strong>550</strong>, obtain it from the network administrator<br />

or manually check for the address in the SYSTEM CONFIG/ETHERNET PORT/IP ADDRESS menu of the<br />

Network Management interface.<br />

You must log in with maximum rights to modify the IP parameters on the <strong>ATLAS</strong> <strong>550</strong> (see<br />

DLP-2, Logging in to the <strong>ATLAS</strong> <strong>550</strong>).<br />

2. Ping the <strong>ATLAS</strong> <strong>550</strong> unit from a remote computer on the network.<br />

Using a remote computer system connected to the LAN, perform an ICMP Ping on the IP Address of<br />

the <strong>ATLAS</strong> <strong>550</strong>. Verify that the unit responds properly. If the <strong>ATLAS</strong> <strong>550</strong> fails to respond, try the<br />

following:<br />

• Verify that the proper IP Address, Subnet Mask, and Default Gateway are provisioned in the unit<br />

(see DLP-3, Setting IP Parameters for the <strong>ATLAS</strong> <strong>550</strong>) for details).<br />

• Verify that the <strong>ATLAS</strong> <strong>550</strong> is properly cabled into the LAN and that the Ethernet cable is properly<br />

seated in the RJ-45 jack on the rear of the unit.<br />

• If the <strong>ATLAS</strong> <strong>550</strong> is connected to a hub or other network device that provides a carrier sense light<br />

for each port, verify that the carrier sense light for the port to which the <strong>ATLAS</strong> <strong>550</strong> is connected<br />

is lit. If this light is not lit, check the cabling between the hub and the shelf. The connection may<br />

also be verified using the ETHERNET LED located on the front panel of the <strong>ATLAS</strong> <strong>550</strong>.<br />

• Verify the IP Address, Subnet Mask, and Default Gateway on the remote computer system.<br />

• If none of these steps are successful, contact the LAN Administrator for assistance.<br />

Refer to the computer system’s documentation if you are unsure how to perform a Ping<br />

command. Most computers running a networked version of Microsoft Windows or UNIX<br />

allow a Ping to be performed by typing ping at a command line prompt.<br />

Typically, the Ping program will respond by indicating that the remote IP Address has<br />

responded in a certain amount of time or that no response was received.<br />

Some versions of Ping will continue running until you explicitly tell them to stop. If the<br />

program does not terminate on its own, type to stop the program.<br />

318 © 2004 ADTRAN, Inc. 61200305L2-1B

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!