ATLAS 550 System Manual - Adtran

More documents

Recommendations

Info

Section 4 User Interface Guide ATLAS 550 System Manual ROUTER > IP > ARP CACHE > TIME Read security: 2 Displays the minutes since the entry was last referenced. ROUTER > IP > ARP CACHE > TYPE Read security: 2 Defines this entry as DYNAMIC or STATIC. ROUTER > IP > ARP CACHE > INTERFACE Read security: 2 Displays the interface upon which this entry was found. ROUTER > IP > ARP CACHE > TX PENDING Read security: 2 Displays the number of transmit packets pending a reply. ROUTER > IP > ROUTES Write security: 2; Read security: 2 The ROUTES menu displays the contents of the ATLAS routing table. All static and discovered routes are displayed from this menu. ROUTER > IP > ROUTES > IP ADDRESS Read security: 2 Displays the IP address of the destination host or network. ROUTER > IP > ROUTES > NETMASK Read security: 2 Displays the subnet mask applied to the destination address. ROUTER > IP > ROUTES > GATEWAY Read security: 2 Displays the IP address of the next-hop router or host receiving the forwarded IP packet. ROUTER > IP > ROUTES > INTERFACE Read security: 2 Displays the next-hop router or host interface through which IP packets are routed, as defined here: LOCAL Forwards the packet directly to the ATLAS router. EN0 IP Forwards the packet through the ATLAS Ethernet port. ENDPOINT NAME Forwards the packet using the DLCI number. 218 © 2004 ADTRAN, Inc. 61200305L2-1B
ATLAS 550 System Manual Section 4 User Interface Guide ROUTER > IP > ROUTES > USED Read security: 2 Displays the number of times the router has referenced this route. ROUTER > IP > ROUTES > CLR Write security: 2; Read security: 2 Clears the USED menu and resets the value to zero. ROUTER > IP > ROUTES > FLAGS Read security: 2 Indicates the properties of this routing table entry, composed of the following letters: H – route is a host route G – route is a gateway route DR – route learned dynamically from RIP I – route learned from an ICMP redirect A – route learned from IARP P – route is private and is not advertised with RIP T – route is to a triggered port (updated only when table changes) ROUTER > IP > ROUTES > HOPS Read security: 2 Displays the number of router hops required to get to the network or host. Ranges from 0 to 16. If set to 16, the route is defined as infinite and cannot be used. ROUTER > IP > ROUTES > COST Read security: 2 Displays the total cost of sending a packet to the specified network. Normally, the cost is based on the available bandwidth. ROUTER > IP > ROUTES > TTL Read security: 2 Displays the number of seconds until the address is removed from table. A value of 999 means the route is static. ROUTER > IP > INTERFACES Write security: 2; Read security: 2 The INTERFACES menu configures and monitors all interfaces connected to the ATLAS router. These include the Ethernet and frame relay DLCIs connected in the PACKET MANAGER/ PACKET CNCTS. 61200305L2-1B © 2004 ADTRAN, Inc. 219
Page 1 and 2:
61200305L2-1B August 2004 ATLAS 550
Page 3 and 4:
ATLAS 550 System Manual Revision Hi
Page 5 and 6:
ATLAS 550 System Manual Compliance
Page 7 and 8:
ATLAS 550 System Manual Industry Ca
Page 9 and 10:
ATLAS 550 System Manual Affidavit f
Page 11 and 12:
ATLAS 550 System Manual Warranty an
Page 13 and 14:
ATLAS 550 System Manual Customer Se
Page 15 and 16:
Table of Contents Section 1 System
Page 17 and 18:
SYSTEM DESCRIPTION Provides an over
Page 19 and 20:
ATLAS 550 System Manual Section 1 S
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
ENGINEERING GUIDELINES Provides equ
Page 27 and 28:
ATLAS 550 System Manual Section 2 E
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
NETWORK TURNUP PROCEDURE Provides s
Page 53 and 54:
ATLAS 550 System Manual Section 3 N
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
USER INTERFACE GUIDE Provides detai
Page 65 and 66:
ATLAS 550 System Manual Section 4 U
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168: ATLAS 550 System Manual Section 4 U
Page 217: ATLAS 550 System Manual Section 4 U
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
Page 309 and 310:
DETAIL LEVEL PROCEDURES DLP-1 Conne
Page 311 and 312:
DLP-1 Connecting a VT100 Terminal o
Page 313 and 314:
DLP-2 Logging in to the ATLAS 550 I
Page 315 and 316:
DLP-3 Setting IP Parameters for the
Page 317 and 318:
DLP-4 Verifying Communications Over
Page 319 and 320:
ATLAS 550 System Manual Section 5 D
Page 321 and 322:
DLP-5 Adding and Removing Users and
Page 323 and 324:
DLP-6 Updating the Firmware Using T
Page 325 and 326:
Page 327 and 328:
DLP-7 Updating the Firmware Using X
Page 329 and 330:
Page 331 and 332:
DLP-8 Saving the Current Configurat
Page 333 and 334:
DLP-9 Loading a Configuration Using
Page 335 and 336:
DLP-10 Saving and Transferring a Cu
Page 337 and 338:
DLP-11 Loading a Configuration Usin
Page 339 and 340:
DLP-12 Connecting the ATLAS 550 to
Page 341 and 342:
DLP-13 Using the ADTRAN Utility Sys
Page 343 and 344:
Page 345 and 346:
DLP-14 Connecting the Alarm Contact
Page 347 and 348:
Page 349 and 350:
DLP-15 Using the Alarm Connections
Page 351 and 352:
CONFIGURATION GUIDES CFG-1 Dial Bac
Page 353 and 354:
CFG-1 Dial Backup for Dedicated T1
Page 355 and 356:
ATLAS 550 System Manual Section 7,
Page 357 and 358:
Page 359 and 360:
Page 361 and 362:
Page 363 and 364:
Page 365 and 366:
SYSTEM EVENT LOGGING Explains the S
Page 367 and 368:
Page 369 and 370:
Page 371 and 372:
Page 373 and 374:
Page 375 and 376:
Page 377 and 378:
Page 379 and 380:
ADTRAN UTILITIES Provides instructi
Page 381 and 382:
ATLAS 550 System Manual Section 8 A
Page 383 and 384:
Page 385 and 386:
Page 387 and 388:
Page 389 and 390:
MIBS Provides a listing of SNMP Man
Page 391 and 392:
ATLAS 550 System Manual Section 9 M
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 401 and 402:
Page 403 and 404:
Page 405 and 406:
Page 407 and 408:
Page 409 and 410:
Page 411 and 412:
show all

ATLAS 550 System Manual - Adtran

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?