ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
DIAL PLAN (V35NX) > USER TERM > IFCE CONFIG > SOURCE ID
Write security: 3; Read security: 5
Simplifies the creation of a dial plan in applications where the criterion for switching calls to a certain
endpoint is a function of which endpoint originated the call.
DEFAULT VALUE = 0. Zero is the default ID for all endpoint and all accept numbers. With default values,
all calls are routed based only on the dialed number.
Multiple endpoints can have the same SOURCE ID.
When creating the CALL ACCEPT list, specify a SOURCE ID(s) as well as a dialed number or range of
dialed numbers to accept.
Example: An application requires that all calls that originate from Port 1 of the ATLAS 550 in Slot 1 be
switched to Port 2 of that same module. Assign a unique SOURCE ID (e.g., 7) to Port 1 of the module, and
then configure Port 2 to only accept calls from that unique SOURCE ID (7).
DIAL PLAN (V35NX) > USER TERM > IFCE CONFIG > MIN DS0’S
Set this to 1 for typical single-call connections. Setting this greater than 1 will restrict connections to
endpoints supporting aggregation (e.g., BONDING) of the specified number of DS0s.
DIAL PLAN (V35NX) > USER TERM > IFCE CONFIG > MAX DS0’S
Set this to 1 for typical single-call connections. Setting this greater than 1 will accommodate connections
to endpoints supporting aggregation (e.g., BONDING) of up to the specified number of DS0s. This also
sets the number of DS0s presented in the negotiation of outgoing aggregate calls.
DIAL PLAN (DUAL USSI MODULE)
DIAL PLAN (USSI) > USER TERM
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports configured for USSI interface connections.
DIAL PLAN (USSI) > USER TERM > IFCE CONFIG
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
294 © 2004 ADTRAN, Inc. 61200305L2-1B