ATLAS 550 System Manual - Adtran

Section 4 User Interface Guide ATLAS 550 System Manual
KEEPALIVE
Write security: 3; Read security: 5
Configures the ATLAS 550 to send keepalive frames on PPP connections that are not currently in use
for data.
PACKET MANAGER > PACKET ENDPNTS > CONFIG > CONFIG - SDLC
Write security: 3; Read security: 5
Contains the configuration parameters for the SDLC packet endpoints.
POLL RESPONSE TIMEOUT
Extreme caution should be used when changing the following parameters from their
default state.
Write security: 3; Read security: 5
Sets the number of seconds the ATLAS 550 waits for a poll response before marking the poll as
unanswered.
MINIMUM POLL TIMER
Write security: 3; Read security: 5
Sets the number of seconds the ATLAS 550 waits between polls. The timer is started when the first
poll is sent and will be restarted when the next poll is sent.
SLOW POLL RATIO
Write security: 3; Read security: 5
Configures the ATLAS 550 to send polls to unresponsive remote units at a slower rate than normal.
The number entered sets the ration. When a remote unit is polled repeatedly and no answer is
received, the ATLAS 550 will move the unit from the normal poll interval to the slow poll interval. If
5 is entered here, the remote units on the slow poll will only get polled after the responsive units have
been polled 5 times.
DISCONNECT THRESHOLD
Write security: 3; Read security: 5
Sets the threshold for considering a remote unit inactive. This is determined using unanswered status
polls.
TRANSMIT DELAY
Write security: 3; Read security: 5
Configures the ATLAS 550 to introduce a delay between packets transmitted on this endpoint (in
seconds). The ATLAS 550 will transmit a packet (any traffic - data, poll, etc.) then wait the entered
seconds before transmitting another packet.
198 © 2004 ADTRAN, Inc. 61200305L2-1B