ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL SEFS THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Severely Errored Framing Seconds (SEFS)
parameter. The default value is 17 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL UAS THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Unavailable Seconds (UAS) parameter. The
default value is 10 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL CSS THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Controlled Slip Seconds (CSS) parameter.
The default value is 4 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL PCV THRSH (D4)
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Path Code Violations (PCV) parameter, when
the Line Type is Super Frame (AT&T D4 format) DS1. The default value is 691 framing errors for an
approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL PCV THRSH (ESF)
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Path Code Violations (PCV) parameter, when
the Line Type is Extended Super Frame DS1. The default value is 132,960 CRC errors for an approximate
BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL LES THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Line Errored Seconds (LES) parameter. The
default value is 648 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > DS1 TOTAL PERF THRESHOLDS > TOTAL LCV THRSH
Write security: 3; Read security: 5
The DS1 performance monitor Threshold Value for the Total Line Code Violations (LCV) parameter. The
default value is 133,400 for an approximate BER level of 10E-5.
SYSTEM CONFIG > SNMP > ASP ENDPOINT COMMUNITIES
Write security: 0; Read security: 0
Configures the ADLP list used when accepting incoming traps from remote ADTRAN TSU 100 Series or
ISU 512 units. For a trap to be recognized and sent to the network management station (NMS) listed in the
TRAPS DESTINATION field, the remote unit must be listed in the ASP ENDPOINT COMMUNITIES list. The ADLP
ADDRESS and ADLP PASSWORD parameters must be configured.
61200305L2-1B © 2004 ADTRAN, Inc. 87