ATLAS 550 System Manual - Adtran

ATLAS 550 System Manual Section 4 User Interface Guide
DIAL PLAN > USER TERM > SIG
Write security: 3; Read security: 5
Defines the type of signaling being used for this connection (endpoint). Select RBS for a T1 using robbed
bit signaling or PRI for a Primary Rate ISDN interface. This selection is only necessary if a T1/PRI is
selected as the SLOT/PORT type.
One HDLC resource is used by each PRI or each Packet Endpoint.
DIAL PLAN > USER TERM > IN#ACCEPT
Write security: 3; Read security: 5
Defines the parameters for the incoming calls that ATLAS 550 accepts from the network.
DIAL PLAN > USER TERM > IN#ACCEPT > SRC ID
Write security: 3; Read security: 5
Identifies the call source ID from which this endpoint accepts calls. This field simplifies the creation of a
dial plan in applications where the criterion for switching calls to a certain endpoint is a function of which
endpoint originated the call. SRC ID may be entered with the usual wild card entries (except $).
X = Any digit 0 through 9
[1,3,5] = Any of these digits
0 = Default value
The default ID for all source endpoints all accept numbers is 0. This results in all calls being routed based
on the dialed number.
DIAL PLAN > USER TERM > IN#ACCEPT > ACCEPT NUMBER
Write security: 3; Read security: 5
Designates which numbers this endpoint will accept (terminate) from the network. The accept list may
consist of multiple entries. The numbers are defined using the following wildcards:
X = Any single digit
N = Any single digit 2 through 9
$ = Any number of digits of any value
9 = This specific number
[1,2,3...] = A single digit in this group
Example: 963-8000 would be a specific incoming number that would be accepted by this endpoint. If this
endpoint consisted of a T1 with multiple DS0s, a “hunt” group for 963-8000 would be formed. The entry $
would accept any call.
Any specific entry will take precedence over a wildcard. For example, if endpoint A was
designated as $ while endpoint B accepted 963-800X, then an incoming call to 963-800X
would only be accepted by endpoint B.
61200305L2-1B © 2004 ADTRAN, Inc. 255