Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade MLXe-8 router 2NOTEWhen inserting the module into the router, be sure that the faceplate does not overlap thefaceplate of an adjacent module.5. Rotate the ejectors until they are flush with the module faceplate. This action will fully seat themodule in the backplane.6. Tighten the screws at each end of the module faceplate by pushing them in and turning themclockwise. Complete the tightening process using the flat-blade screwdriver.7. Enter the write memory command to ensure that the slot will be correctly configured for thenew module after a reboot.Brocade(config)# write memoryWrite startup-config done.FIGURE 54Installing a module in a Brocade MLXe-8 router8. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane.Modules have a snug fit for maximum EMI protection.9. Tighten the two screws on each side of the module faceplate by pushing them in and turningthem clockwise. Complete the tightening process using a flat-blade screwdriver.Installing power supplies in the Brocade MLXe-8 routerYou need a small Phillips or flat-blade screwdriver to install additional power supplies.Follow these steps to install a power supply in the Brocade MLXe-8 router.1. Remove the power supply slot blank.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 8553-1002373-02