Brocade MLX Series and Brocade NetIron XMR Hardware ...

Managing interface modules 7Specifying an immediate boot from the auxiliary flash slots on the management moduleTo specify an immediate boot for the interface module installed in slot 1 from the auxiliary flash sloton the management module, enter the lp boot system command at the Privileged EXEC level of theCLI.Brocade# lp boot system slot1 primary 1Syntax: lp boot system slot1 | slot2 • The slot1 and slot2 keywords indicate the auxiliary flash slot on the management module fromwhich to boot the interface module.• The parameter specifies the name of the image from which to boot the interfacemodule.• The parameter specifies the device slot number that contains the interfacemodule that will undergo an immediate boot. You can specify 1 – 4 for 4-slot devices, 1 – 8 for8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.Specifying an immediate boot from management module flash memoryTo specify an immediate boot from the primary image on the management module for the interfacemodule installed in slot 1, enter the following command at the Privileged EXEC level of the CLI.Brocade# lp boot system mp primary 1Syntax: lp boot system mp primary | secondary • The primary and secondary keywords specify the primary or secondary software image in flashmemory on the management module.• The parameter specifies the device slot number that contains the interfacemodule that will undergo an immediate boot.You can specify 1 – 4 for 4-slot devices, 1 – 8 for8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.Specifying an immediate boot from flash memory on the interface moduleTo specify an immediate boot from the primary image in flash memory on the interface moduleinstalled in slot 1, enter the following command at the Privileged EXEC level of the CLI.Brocade# lp boot system flash primary 1Syntax: lp boot system flash [primary | secondary] • The primary and secondary keywords specify the primary or secondary image in the interfacemodule flash memory.• The parameter specifies the slot number that contains the interface modulethat will undergo an immediate boot.You can specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slotdevices, 1 – 16 for 16-slot devices, or 1 – 32 for 32-slot devices.Specifying an immediate boot from a TFTP serverTo specify an immediate boot for the interface module installed in slot 1 from a TFTP server, enterthe following command at the Privileged EXEC level of the CLI.Brocade# lp boot system tftp 123.123.123.123 primary 1Syntax: lp boot system tftp • The parameter specifies the IP address of the TFTP server from which theinterface module will be booted.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 34153-1002373-02