Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade MLXe-16 router 2FIGURE 57Crimping the power supply wire in the lug11 AWG power supply wire:#8 AWG power supply wire for 1200W power supplies#6 AWG power supply wire for 1800W power supplies4. Connect the -48V cable to the negative terminal and the 0V cable to the positive terminal.NOTEDC return must be isolated from the router ground (DC-I) when connecting to DC powersupplies.5. Replace the transparent cover.This equipment installation must meet NEC/CEC code requirements. Consult local authorities forregulations.Final stepsComplete these final steps in the order listed:• “Attaching a management station”• “Activating the power source”• “Verifying proper operation”Installing a Brocade MLXe-16 routerThe following sections describe how to install a Brocade MLXe-16 router.NOTEIllustrations may differ slightly from the actual equipment.Preparing the installation siteBefore installing the router, plan the location and orientation relative to other devices andequipment. For cooling purposes, allow a minimum of six inches of space between the sides, front,and the back of the router and walls or other obstructions. If you are installing the router in aperforated enclosure, the perforations must cover at least 60 percent of the surface.Ensure that the proper power and network cabling is installed at the site. For information aboutcabling, refer to “Installing power supplies in a Brocade MLXe-16 router” on page 96,and “Attachinga management station” on page 140.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 8953-1002373-02