Brocade MLX Series and Brocade NetIron XMR Hardware ...

4Attaching a management stationRemoving Brocade NetIron XMR 3200 router DC power suppliesFollow these steps to remove a 2400W DC power supply in a Brocade NetIron XMR 3200 router:1. Ensure the main DC power breaker is OFF.2. Use a #1 Phillips screwdriver to remove the screws that secures the safety cover, as shown inFigure 207 on page 293. Remove the safety cover.3. Use a #2 Phillips screwdriver to remove the screws securing the power lugs. Refer toFigure 208 on page 294.4. Pull down on handle to remove power supply. Refer to Figure 205 on page 291.Follow these steps to remove a 3000W DC power supply in a Brocade NetIron XMR 3200 router:1. Ensure the main DC power breaker is OFF.2. Use a #1 Phillips screwdriver to remove the screw that secures the safety cover, as shown inFigure 207 on page 293.3. Pull down on the handle to remove the 3000W power supply. Refer to Figure 205 on page 291.4. Use a #2 Phillips screwdriver to remove the screws securing the power lugs. Refer toFigure 208 on page 294.Final stepsFollow these steps in the order listed to complete the installation:• “Attaching a management station”• “Activating the power source”• “Verifying proper operation”Attaching a management stationYou can manage your router in the following ways:• Connect a PC or terminal to the console port on the management module. From this port, youcan assign an IP address to the management module and establish connections throughTelnet or SSH.• Connect the router to your existing management network and manage the router and othernetwork devices from a management station.NOTEThe management network that you connect to through the 10/100 Ethernet port must beseparate and isolated from the network over which user packets are switched and routed. Forinformation about functionality on the management port, Refer to “Understandingmanagement port functions” on page 317.296 Brocade MLX Series and NetIron XMR Hardware Installation Guide53-1002373-02