Brocade MLX Series and Brocade NetIron XMR Hardware ...

2Installing a Brocade MLXe-4 router5. Rotate the ejectors until they are flush with the module front panel. This action will fully seatthe module in the backplane.6. Tighten the screws at each end of the module faceplate by pushing them in and turning themclockwise. Complete the tightening process using the flat-blade screwdriver.7. Enter the write memory command to ensure that the slot will be correctly configured for thenew module after a reboot.Brocade(config)# write memoryWrite startup-config done.FIGURE 48Installing a moduleInstalling power supplies in a Brocade MLXe-4 routerYou need a small Phillips or flat-blade screwdriver to install power supplies.Follow these steps to install a power supply.1. Remove the power supply slot blank and store it for future use.2. Remove the power supply from the packaging.3. Insert the power supply into the slot and slide it along the guides on each side of the slot. Referto Figure 49.NOTEEmpty power supply slots must be covered with slot blanks.NOTEDo not overtighten screws when installing power supplies.CAUTIONCarefully follow the mechanical guides on each side of the power supply slot and make sure thepower supply is properly inserted in the guides. Never insert the power supply upside down.76 Brocade MLX Series and NetIron XMR Hardware Installation Guide53-1002373-02