Brocade MLX Series and Brocade NetIron XMR Hardware ...

1Router modules8x10GE-X interface module LEDsThe 8x10GE-X interface module LEDs indicate module and port status, as described in Table 7.TABLE 7 8x10GE-X module LEDsLED Location State MeaningPower Lower left corner of module Green Module is receiving powerOffModule is not receiving powerLink/ActBelow the ports. Top portLED on left, bottom port LEDon right.GreenblinkingOffPort enabled and link is passing traffic. LED is solidgreen when link is idle.Port is disabled.Power supply requirements for 8x10GE-X modulesTable 8 lists the power supply requirements for each type of router when installing 8x10GE-Xmodules.TABLE 8 Power supply requirements for 8x10GE-X modulesRouter typeNumber of 8x10GE-X Power supply requirementsmodules installedMLXe-4 one one 1200W PSUfor 1+1 redundancy, install two 1200W PSUMLX-4 andBrocade NetIronXMR 4000MLXe-8 andBrocade NetIronXMR 8000two to fourfourseveneighttwo 1200W PSUfor 2+2 redundancy, install four 1200W PSUone 1800W PSUfor 1+1 redundancy, install two 1800W PSUone 1200W PSUfor 1+1 redundancy, install two 1200W PSUtwo 1200W PSUfor 2+2 redundancy, install four 1200W PSUthree 1200W PSUfor 3+1 redundancy, install four 1200W PSUtwo 1800W PSUfor 2+3 redundancy, install four 1800W PSUAll 16-slot routers fifteen four 1200W PSUfor 4+4 redundancy, install eight 1200W PSUsixteenfive 1200W PSUfor 5+3 redundancy, install eight 1200W PSUfour 1800W PSUfor 4+4 redundancy, install eight 1800W PSUAll 32-slot routers twenty-eight four 2400W PSUfor 4+4 redundancy, install eight 2400W PSUtwenty-nine tothirty-twofive 2400W PSUfor 4+4 redundancy, install eight 2400W PSUfour 3000W PSUfor 4+4 redundancy, install 3000W PSU28 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02