Brocade MLX Series and Brocade NetIron XMR Hardware ...

Router modules 1TABLE 6Router typePower supply requirements for 100xGbE modules (Continued)Number of 100xGbE Power supply requirements (minimum required-redundancy requirements)modules installedMLXe-16 six four 1200W PSUfor 4+4 redundancy, install eight 1200W PSUfor 3+3 redundancy, install four 1800W PSUBrocade NetIronXMR 16008x10GE-X interface modulesThe 8x10GE-X interface modules provide 8 ports of 10 Gigabit Ethernet with support for 1M IPv4routes in hardware.NOTEGen-2 8x10GE-X modules require high speed switch fabric modules to operate. You can replaceswitch fabric modules with high-speed switch fabric modules while the system is powered on andrunning. For more information about high-speed switch fabric modules, refer to “High-speed switchfabric modules” on page 50.Figure 16 shows the faceplate of the 8x10GE-X module.FIGURE 16seven to eighteight (1x100GE)8x10GE-X module faceplatea minimum of five 1200W PSUfor 4+4 redundancy, install eight 1800W PSUfor 5+3 redundancy, install eight 1200W PSUfour 1200W PSUfor 4+4 redundancy, install eight 1200W PSUMLXe-32 twelve four 2400W PSUfor 4+4 redundancy, install eight 2400W PSUBrocade NetIronXMR 3200thirteen to sixteensixteen (1x100GE)five 2400W PSUfor 5+3 redundancy, install eight 2400W PSUfour 3000W PSUfor 4x4 redundancy, instal eight 3000W PSUfour 2400W PSUfor 4+4 redundancy, install eight 2400W PSU17288x10GE-X modules support SFP+ optics only; they do not support SFP or CFP optics. For a list ofsupported SFP+ optics, refer to the latest version of the Brocade Optics Family Data Sheet,available online in the following location:http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/Optics_DS.pdfBrocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 2753-1002373-02