Brocade MLX Series and Brocade NetIron XMR Hardware ...

Replacing fan assemblies 86. Place the handle over the upward deflector aligning the handle with the screw holes andsecure the handle to the upward deflector and fan assembly faceplate with the two screws.Refer to Figure 251.FIGURE 251Upward deflector oriented correctly between the handle and fan assembly faceplate7. Re-attach the fan assembly faceplate to the fan assembly by securing three screws on eachside.NOTEReplacing the tape is not required.Reinstalling the modified fan assembly in the chassisTo reinstall the modified fan assembly, complete the following steps:1. Insert the modified fan assembly into the fan slot and push the assembly in until the fanassembly faceplate is flush with the chassis. Pushing the fan assembly in seats the fanconnector in the router connector.2. Secure the fan assembly to the router by replacing and tightening the four screws.3. Check the fan status LED in the lower left corner of the faceplate. It will glow red momentarilywhen power is applied, and then it will change to green when the fan comes up to speed.4. To verify that the fan is operating correctly, access the CLI and enter the show chassiscommand.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 37753-1002373-02