Brocade MLX Series and Brocade NetIron XMR Hardware ...

3Installing a Brocade MLX-32 routera. Use the show running-config command in config mode to determine the currentconfiguration of the slot.Brocade(config)# show running-configCurrent configuration:!ver V5.0.0T163module 1 ni-mlx-20-port-1g-copper!This example shows that slot 1 has already been configured for a 20-port 1g copperinterface module.b. With the module designation from show running-config command output, use the nomodule command to remove the configuration from slot 1.Brocade(config)# no module 1 ni-mlx-20-port-1g-copperThis example removes the configuration from slot 1, leaving it ready for a new module.2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector onthe front of the router.3. Remove the module from the packaging.4. Insert the module into the router slot, and slide the card along the card guide until the ejectorson either side of the module rotate towards the module faceplate. Refer to Figure 148.NOTEWhen inserting the module into the router, make sure that the faceplate does not overlap thefaceplate of an adjacent module.5. Rotate the ejectors until they are flush with the module faceplate. This action will fully seat themodule in the backplane.6. Tighten the screws at each end of the module faceplate by pushing them in and turning themclockwise. Complete the tightening process using the flat-blade screwdriver.7. Enter the write memory command to ensure that the slot will be correctly configured for thenew module after a reboot.Brocade(config)# write memoryWrite startup-config done.212 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02