Brocade MLX Series and Brocade NetIron XMR Hardware ...

Managing interface modules 7Syntax: lp boot system mp [primary | secondary] [all | ]• The primary and secondary keywords specify the primary or secondary image in flash memoryon the management module.• The all | parameter specifies that the automatic boot applies to all interfacemodules in the device, or to an interface module in the specified device slot number only. Youcan specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot devices, 1 – 16 for 16-slot devices, or 1 –32 for 32-slot devices.Configuring an automatic boot from flash memory on the interface moduleTo configure an automatic boot from the primary image in flash memory on the interface modulefor all interface modules, enter the following command at the global CONFIG level of the CLI.Brocade(config)# lp boot system flash primary allSyntax: lp boot system flash [primary | secondary] [all | ]• The primary and secondary keywords specify the primary or secondary image in the interfacemodule flash memory.• The all | parameter specifies that the automatic boot applies to all interfacemodules in the device or to an interface module in the specified slot number only. You canspecify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for32-slot devices.Configuring an automatic boot from a TFTP serverTo configure an automatic boot for all interface modules from a TFTP server, enter the followingcommand at the global CONFIG level of the CLI.Brocade(config)# lp boot system tftp 123.123.123.123 primary allSyntax: lp boot system tftp [all | ]• The parameter specifies the IP address of the TFTP server from which theinterface modules will be booted.• The parameter specifies the name of the image from which to boot the interfacemodules.• The all | parameter specifies that the automatic boot applies to all interfacemodules in the router or to an interface module in the specified router slot number. You canspecify 1 – 4 for 4-slot routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for32-slot routers.Configuring an automatic interactive bootTo configure an automatic interactive boot for all interface modules, enter the following commandat the global CONFIG level of the CLI.Brocade(config)# lp boot system interactive allSyntax: lp boot system interactive [all | ]The all | parameter specifies that the automatic boot applies to all interfacemodules in the router, or to an interface module in the specified slot number. You can specify 1 – 4for 4-slot routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for 32-slot routers.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 34353-1002373-02