Brocade MLX Series and Brocade NetIron XMR Hardware ...

3Installing a Brocade MLX-32 router1 AWG power supply wire:#8 AWG wire for 1200W power supply#6 AWG wire for 1800W power supply4. Connect the -48V cable to the negative terminal and the 0V cable to the positive terminal onthe power supply.NOTEDC return must be isolated from the router ground (DC-I) when connecting to the power supply.5. Replace the transparent cover.This equipment installation must meet NEC/CEC code requirements. Consult local authorities forregulations.Final stepsComplete these steps in the order listed:• “Attaching a management station”• “Activating the power source”• “Verifying proper operation”Installing a Brocade MLX-32 routerThe Brocade MLX-32 router can be installed on a 2-post Telco open frame rack or a 4-postenclosed rack or cabinet.Preparing the installation siteBefore installing the router, plan the location and orientation relative to other devices andequipment. For cooling purposes, allow a minimum of six inches of space between the sides, front,and the back of the router and walls or other obstructions. If a router is installed within a perforatedenclosure, the perforations must cover at least 60 percent of the surface.You will need to use a mechanical lift to move and install the router. Be sure to allow enoughworking room for the lift.NOTEMake sure your site provides 200-240 AC power.Ensure that the proper power and network cabling is installed at the site.For information on cabling, refer to “Brocade MLX-32 cable management” on page 213, “Installingpower supplies in a Brocade MLX-32 router” on page 222, “Attaching a management station” onpage 227, and “Connecting the router to a network device” on page 317.Unpacking a Brocade MLX-32 routerThe Brocade MLX-32 router ships with the following items:190 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02