Brocade MLX Series and Brocade NetIron XMR Hardware ...

4Installing a Brocade NetIron XMR 4000 routerFIGURE 171Installing a module in the Brocade NetIron XMR routerNOTEWhen inserting the module into the router, make sure that the faceplate doesn’t overlap withthe faceplate of an adjacent module.4. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane.Modules have a snug fit for maximum EMI protection.5. Tighten the screws at each end of the module faceplate by pushing them in and turning themclockwise. Complete the tightening process using the flat-blade screwdriver.Installing Brocade NetIron XMR 4000 router power suppliesYou will need a small Phillips or flat-blade screwdriver to install power supplies.Follow these steps to install a power supply.1. Remove the power supply slot blank.2. Remove the power supply from the packaging.3. Insert the power supply into the empty power supply slot, using the card guides on each side ofthe slot. Slide the card along the card guides until the ejectors on either side of the powersupply rotate towards the faceplate.NOTEEmpty power supply slots must be covered with slot blanks.Do not overtighten screws when installing power supplies.CAUTIONCarefully follow the mechanical guides on each side of the power supply slot and make sure thepower supply is properly inserted in the guides. Never insert the power supply upside down.248 Brocade MLX Series and NetIron XMR Hardware Installation Guide53-1002373-02