Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade MLXe-4 router 2Installing a Brocade MLXe-4 routerThis section describes how to install a Brocade MLXe-4 router.Preparing the installation siteBefore installing the router, plan the location and orientation relative to other devices andequipment. For cooling purposes, allow a minimum of six inches of space between the sides, front,and the back of the router and walls or other obstructions. If a router is installed in a perforatedenclosure, the perforations must cover at least 60 percent of the surface.NOTEThis equipment is suitable for installation in a Network Telecommunication facility and where NECrequirements apply. Additionally, it may be installed in either a Common Bonding Network (CBN) orIsolated Bonding Network (IBN). It is not intended for Outside Plant (OSP) installations.Ensure that the proper cabling is installed at the site.For information on cabling, refer to “Installing power supplies in a Brocade MLXe-4 router” onpage 76, “Attaching a management station” on page 140, and “Connecting the router to a networkdevice” on page 317.Unpacking a Brocade MLXe-4 routerThe Brocade MLXe-4 router ships with the following items:• Router chassis with switch fabric modules installed in slots marked SF, slot blanks installed inall empty module slots, and mounting brackets attached for front-mount.• Insertion or extraction tool for use with RJ45 and fiber-optic connectors.NOTEIf any items are missing, contact the place of purchase.Follow these steps to unpack your Brocade MLXe-4 router.1. Remove the router from the shipping carton.2. Save the shipping carton and packing materials in case you need to move or ship the router ata later time.Installing a Brocade MLXe-4 router in a rack or cabinetYour Brocade MLXe-4 router ships from the factory with mounting brackets attached. You canmount your router in the following ways:• Front-mount in a standard two-post rack using the factory-installed brackets.• Mid-mount in a standard two-post rack by moving the factory-installed brackets to the center ofthe device• Mount the device in a four-post rack or cabinet using the Cabinet Mount Kit. Refer to “” onpage 146.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 7153-1002373-02