Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade NetIron XMR 8000 router 4NOTEFor the NEBS-compliant installation, AC power connections must use a surge protection device(SPD) to protect AC power supplies from damage due to excessive power line surges.Follow these steps to connect AC power source.1. Locate the power receptacle on the back panel of the router.2. Lift the cord retainer and connect an AC power cord to the power supply.3. Snap the cord retainer over the power plug to hold it in place.FIGURE 181Connecting a power cord to the power receptaclee12341 Lift handle 3 Power cord2 Cord retainer 4 Ground pointDANGERIf the installation requires a different power cord than the one supplied with the router, makesure you use a power cord displaying the mark of the safety agency that defines the regulationsfor power cords in your country. The mark is your assurance that the power cord can be usedsafely with the router.For information about powering on the system, refer to “Activating the power source” on page 297.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 25953-1002373-02