Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade NetIron XMR 32000 router 4FIGURE 203Routing lower-right quadrant cables12341 Lower right quadrant 3 Comb B (slots #27 and #28 cables)2 Comb A (slots #29 and #30 cables) 4 Comb C (slots #25 and #26 cables)2. Route cables from slots #30 and #29 down through comb A. Refer to Figure 203.3. Route cables from slots #28 and #27 down through comb B.4. Route cables from slots #26 and #25 down through comb C.Accessing modules for serviceWith the cables bundled correctly, it is easier to access the modules for service. Gently move thecable bundles to the side to access a module. Use the appropriate Phillips or flat-blade screwdriverwith an extended shaft to disconnect the cables from the module and remove the module. There isno need to undo the cable cinches or cable ties. Refer to Figure .NOTEThis procedure is easier with two people. One person can hold the cable bundles aside while theother person loosens the connectors and removes the module.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 28953-1002373-02