Brocade MLX Series and Brocade NetIron XMR Hardware ...

Replacing an interface module 8FIGURE 228Inserting a compact flash card in the MR2 management moduleReplacing an interface moduleYou can remove or replace interface modules while the router is powered on and running. For moreinformation on module slot locations, refer to Chapter 1, “Product Overview”.NOTEIt is not recommended that you hot-swap an interface module that is running a software image olderor newer than the image on the management module. Although the management module willattempt to sync the application image on the interface module, it may not be able to sync older FPGAimages. In this case the interface module may attempt to continuously reload. Always upgrade ordowngrade the FPGA images on replacement interface modules to match the software version onthe management module before you install the interface modules in your device.For information about how to install a new or replacement module, refer to the installation chapterfor your router model.CAUTIONIf you are hot-swapping a component, allow a minimum of two seconds after a component hasbeen removed before inserting a replacement component in the same slot.Removing and replacing an interface moduleTo remove or replace an interface module, see the module instructions in the installation chapterthat is appropriate for your router model.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 35153-1002373-02