Brocade MLX Series and Brocade NetIron XMR Hardware ...

3Installing a Brocade MLX-32 router• During the initial installation of modules, it is recommended that you insert all the modulesinto the appropriate router slots before tightening the module screws.For instructions about installing 100xGbE interface modules, refer to “Installing 2x100GbEinterface modules in Brocade MLX routers” on page 151.For information about how to disable and re-enable power to interface modules, see “Disabling andre-enabling power to interface modules” on page 321When populating the Brocade MLX-32 router, the modules must be installed in the appropriateslots:• Management modules - management slots 1 and 2• Switch fabric modules - switch fabric slots 1-8• Interface modules - interface slots 1-32Figure 12 on page 16 shows the locations of these slots.Using the insertion and extraction toolDue to the high density of cables that the Brocade MLX-32 router can support, it may be difficult toinsert and remove the RJ45 and optical connectors, especially when replacing an existing module.An insertion and extraction tool has been provided in the Brocade MLX-32 accessory kit to makethis task easier. Refer to Figure 147.FIGURE 147insertion and extraction tool211 Hooked tab 2 Stepped tabUse the tool to grasp the plug of the modular connector at its narrow end (the end closest to theattached cable), and insert the connector into the proper interface module. Grasping the plug atthe wide end during insertion may result in the tool being difficult to release and remove.When using the tool to extract the plug of a modular connector, cover the entire length of the plugwith the tool. Notice that one end of the tool has a “hook” side. Use this side to compress thelocking tab while you remove the connector.The Brocade MLX-32 ships with empty module slots, and upper and lower shipping panelsinstalled.DANGERThe intra-building ports of the equipment or subassembly is suitable for connection tointra-building or unexposed wiring or cabling only. The intra-building ports of the equipment orsubassembly MUST NOT be metallically connected to interfaces that connect to the outside plant(OSP) or its wiring. These interfaces are designed for use as intra-building interfaces only (Type 2210 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02