Brocade MLX Series and Brocade NetIron XMR Hardware ...

4Installing a Brocade NetIron XMR 32000 routerFIGURE 192L-brackets that secure the Brocade NetIron XMR 32000 router to the inner pallet11 L-brackets (two brackets on either side of router)4. Use a mechanical lift equipped with a lift plate. Position the lift plate as close to the front of therouter as possible. Adjust the lift plate height to be even with the bottom of the router.5. Slide the router onto the lift plate.DANGERA Brocade NetIron XMR 32000 router is extremely heavy, even when it is unpopulated. Four ormore people are required to position the unpopulated router into the rack.DANGERDo not use the handles on the power supply units or fan modules to position the router.6. Secure the router to the mechanical lift with a strap to prevent tipping.7. Carefully position the router in front of the rack where it is to be installed.8. Remove the strap securing the router to the lift.9. With two people in front and two people in back, slide the router into the rack.10. If you are installing the router in a four-post rack or cabinet, install a mounting screw and acage nut into each of the holes aligned with the threaded holes in the spacer bars. If you areinstalling the router in an open-frame rack, install four standard #12-24 pan-head screws intothe keyhole mounting holes aligned with the rack.11. Visually inspect the alignment of the router. If the router is installed properly in the rack, themounting screws on one side of the rack should align with the mounting screws on theopposite side and the router should be level. Add all additional screws.276 Brocade MLX Series and NetIron XMR Hardware Installation Guide53-1002373-02