Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade MLXe-16 router 2You can install up the three Brocade MLXe-16 routers in a standard 19-inch (EIA310-D) rack.If you are installing your Brocade MLXe-16 router in a cabinet or 4-post rack, refer to “” onpage 146.Front- or mid-mount in a standard rackFollow these steps to mount a Brocade MLXe-16 router in a rack.You will need to provide standard #12-24 pan-head screws to mount each router in a rack. You willneed a Phillips screwdriver to perform this task.NOTEWhen connecting the device to the rack frame, use thread-forming screws and paint-piercingwashers.1. Determine the position of each router in the rack. For example, place routers with the fewestmodules near the top of the rack, routers with more modules near the middle of the rack, andfully populated routers near the bottom of the rack.2. Position four mounting screws for each router using the spacing of the keyhole slots (the oneswith the narrow portion pointing up) on the mounting brackets as a guide, as shown inFigure 58. When tightening the mounting screws, leave approximately 1/4 inch of clearancebetween the back of the screw head and the rack posts.FIGURE 58Positioning the mounting screws in the rack posts5" 3"1 21 Unequal flange equipment rack 2 Network equipment rack3. Starting with the router that will be in the lowest position in the rack, mount the router in therack as shown in Figure 59. With two or more people lifting the router, slip the wide portion ofeach keyhole slot over the corresponding mounting screw in the rack post.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 9153-1002373-02