Brocade MLX Series and Brocade NetIron XMR Hardware ...

6Connecting the router to a network deviceInstalling a fiber-optic transceiverTo connect a router to another network device using a fiber port, install a fiber-optic transceiver(SFP, SFP+, or XFP, as required by your interface module).DANGERAll fiber-optic interfaces use Class 1 Lasers.NOTERefer to “Installation precautions” on page 147 for other hardware installation precautions.Before installing a fiber-optic transceiver, have on hand an ESD wrist strap with a plug forconnection to the ESD connector on the router chassis.DANGERFor safety reasons, the ESD wrist strap should contain a 1 megohm series resistor.Follow these steps to install a fiber-optic transceiver.1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector onthe router chassis.2. Remove the transceiver from the protective packaging.3. Remove the metal cover from the port on the interface module.4. Gently insert the fiber-optic transceiver into the port until the transceiver clicks into place.Transceivers are keyed to prevent incorrect insertion.Cabling a fiber-optic transceiverFollow these steps to cable a fiber-optic transceiver.1. Remove the protective covering from the fiber-optic port connectors and store the covering forfuture use.2. Before cabling a fiber-optic transceiver, it is strongly recommended that you clean the cableconnectors and the port connectors. For more information, refer to “Cleaning fiber-optic portsand connectors”.3. Gently insert the two cable connectors (a tab on each connector should face upward) into theports until the tabs lock into place.318 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02