Brocade MLX Series and Brocade NetIron XMR Hardware ...

3Installing a Brocade MLX-4 routerCurrent configuration:!ver V5.0.0T163module 1 ni-mlx-20-port-1g-copper!This example shows that slot 1 has already been configured for a 20-port 1Gig copperinterface module.b. With the module designation from show running-config command output, use the nomodule command to remove the configuration from slot 1.Brocade(config)# no module 1 ni-mlx-20-port-1g-copperThis example removes the configuration from slot 1, leaving it ready for a new module.2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector onthe front of the router.3. Remove the module from the packaging.4. Insert the module into the router slot, and slide the card along the card guide until the ejectorson either side of the module move close to the module front panel. Refer to Figure 112.NOTEWhen inserting the module into the router, be sure that the faceplate does not overlap thefaceplate of an adjacent module.5. Rotate the ejectors until they are flush with the module front panel. This action will fully seatthe module in the backplane.6. Tighten the screws at each end of the module faceplate by pushing them in and turning themclockwise. Complete the tightening process using the flat-blade screwdriver.7. Enter the write memory command to ensure that the slot will be correctly configured for thenew module after a reboot.Brocade(config)# write memoryWrite startup-config done.FIGURE 112Installing a moduleInstalling Brocade MLX-4 router power suppliesYou need a small Phillips or flat-blade screwdriver to install power supplies.160 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02