Brocade MLX Series and Brocade NetIron XMR Hardware ...

Installing a Brocade MLX-32 router 3FIGURE 157Routing lower-right quadrant cables12341 Lower right quadrant 3 Comb B (slots #27 and #28 cables)2 Comb A (slots #29 and #30 cables) 4 Comb C (slots #25 and #26 cables)2. Route cables from slots #30 and #29 down through comb A. Refer to Figure 157.3. Route cables from slots #28 and #27 down through comb B.4. Route cables from slots #26 and #25 down through comb C.Accessing modules for serviceWith the cables bundled correctly, it is easier to access the modules for service. Gently move thecable bundles to the side to access a module. Use the appropriate Phillips or flat-blade screwdriverwith an extended shaft to disconnect the cables from the module and remove the module. There isno need to undo the cable cinches or cable ties. Refer to Figure 158.NOTEThis procedure is easier with two people. One person can hold the cable bundles aside while theother person loosens the connectors and removes the module.CAUTIONBe careful not to overtighten or cross-thread cable connector screws.Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 22153-1002373-02