Brocade MLX Series and Brocade NetIron XMR Hardware ...

1Router modulesNOTEFan upgrades are not required on Brocade MLX-16 routers.To display information about NIBI-16-FAN-EXH-A modules installed in a 16-slot router, enter theshow chassis command.Brocade# show chassis*** Brocade MLX-16 chassis ***Power 1 (H1250CFN - AC 1200W): Installed (OK)Power 2: Installed (Failed or Disconnected)Power 3: not presentPower 4: Installed (Failed or Disconnected)Power 5: (H1250CFN - AC 1200W): Installed (OK)Power 6: (30351200 - AC 1200W): Installed (OK)Power 7: Installed (Failed or Disconnected)Power 8: (30351200 - AC 1200W): Installed (OK)Total power budget for chassis = 4800 WTotal power used by system core = 762 WTotal power used by LPs = 1040 WTotal power available = 2998 WSlot Power-On Priority and Power Usage:Slot10 pri=1 module type=NI-MLX-1Gx48-T-A 48-port 10/100/1000Base-T MRJ21Module power usage=260WSlot11 pri=1 module type=NI-MLX-1Gx48-T-A 48-port 10/100/1000Base-T MRJ21Module power usage=260WSlot13 pri=1 module type=NI-MLX-1Gx48-T-A 48-port 10/100/1000Base-T MRJ21Module power usage=260WSlot16 pri=1 module type=NI-MLX-1Gx48-T-A 48-port 10/100/1000Base-T MRJ21Module power usage=260W--- FANS ----Bottom fan tray (fan 1): Status = OK, Speed = LOW (50%)Bottom fan tray (fan 2): Status = OK, Speed = LOW (50%)Bottom fan tray (fan 3): Status = OK, Speed = LOW (50%)Bottom fan tray (fan 4): Status = OK, Speed = LOW (50%)Bottom fan tray (fan 5): Status = OK, Speed = LOW (50%)Bottom fan tray (fan 6): Status = OK, Speed = LOW (50%)Rev A Back Fan A (revision 0x09): Status = OK, Speed = LOW (50%)Rev A Back Fan B (revision 0x0c): Status = OK, Speed = LOW (50%)The output displays firmware Revision A (Rev A) for NIBI-16-FAN-EXH-A modules. Rev Aindicates that the router contains the required rear fan modules to support theNI-MLX-1Gx48-T-A modules. The RPM value thresholds (LOW/MED/MED-HI/HI) are alsodisplayed for rear fan modules.NOTEIf the router does not contain NIBI-16-FAN-EXH-A modules, the show chassis command will notdisplay Rev A for rear fan modules.POS interface modulesBrocade MLX and Brocade NetIron XMR routers support the following Packet Over SONET or SDH(POS) interface modules:• Dual speed (OC-48c or STM-16)/(OC-12c or STM-4) – Available with 2, 4, or 8 ports• Single speed OC-192c or STM-64 – Available with 1 or 2 portsBrocade MLXe routers support POS interface modules, beginning with release 05.0.00 and later.44 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02