VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

Blackfin Processor Loader Guide
Table 2-10. Blackfin Loader Command-Line Switch Summary (Cont’d)
Switch Description
-o2 The -o2 switch produces two output files: one for the init block (if
present) and boot kernel and one for user application code.
To have a different format, boot mode, or output width from the
application code output file, use the -kb -kf -kwidth switches to
specify the boot mode, the boot format, and the boot width for the
output kernel file, respectively.
� Do
� Combine
not combine the -o2 switch with -nokernel on
ADSP-BF535 processors.
-o2 with -l filename and/or -init
filename on ADSP-BF531/BF532/BF533,
ADSP-BF534/BF536/BF537/BF538/BF539,
ADSP-BF561/BF566 processors.
-p # The -p # switch specifies a hex PROM/flash output start address for
the application code. A valid value is between 0x0 and 0xFFFFFFFF.
A specified value must be greater than that specified by -kp if both
kernel and/or initialization and application code are in the same
output file (a single output file).
-pFlag # The -pflag # switch specifies a 4-bit hex value for a strobe (programmable
flag). The default value is zero (0x0).
-pFlag PF#
-pFlag PG#
-pFlag PH#
� The
-pflag # switch is applicable to ADSP-BF531,
ADSP-BF532/BF533/BF534, ADSP-BF536/BF537,
ADSP-BF538/BF539 processors only.
The -pflag PF#|PG#|PH# switch specifies a 4-bit hex value for
one of the ports: PF, PG, or PH (there is no default value).
� The
-pflag PF#|PG#|PH# switch is applicable to
ADSP-BF531/BF532/BF533 (silicon revision 0.2
and above) and BF534/BF536/BF537 (silicon revision
0.1 and above).
2-70 VisualDSP++ 4.5 Loader and Utilities Manual