VisualDSP++ 4.5 Loader and Utilities Manual - Analog Devices

Loader for ADSP-21161 SHARC Processors
Using ADSP-21161 Loader Command Line
Use the following syntax for the ADSP-21161 loader command line.
elfloader inputfile -proc ADSP-21161 -switch [-switch…]
where:
� Command-line
inputfile—Name of the executable file (.dxe) to be processed
into a single boot-loadable file. An input file name can include the
drive and directory. Enclose long file names within straight quotes,
“long file name”.
-proc ADSP-21161—Part number of the processor for which the
loadable file is built. The -proc switch is mandatory.
-switch …—One or more optional switches to process. Switches
select operations and boot modes for the loader utility. A list of all
switches and their descriptions appear in Table 4-10 on page 4-28.
switches are not case-sensitive and placed on the
command line in any order.
Single-Processor Systems
The following command line,
elfloader Input.dxe -bSPI -proc ADSP-21161
runs the loader utility with:
Input.dxe—Identifies the executable file to process into a
boot-loadable file for a single-processor system. Note that the
absence of the -o switch causes the output file name to default to
Input.ldr.
VisualDSP++ 4.5 Loader and Utilities Manual 4-25